Crow Runner Link Bedienungsanleitung PDF herunterladen (Seite 14)

RUNNER LINK Gateway Configuring the Runner Link

3. On the Runner Link board, press the Config button for minimum of 3

seconds.

The red FAIL LED lights and then after 3 seconds the green NET LED lights

as well and the green SYSTEM LED starts to blink. There is an audible beep

from your PC (acknowledgment) and the FAIL and NET LEDS turn off. The

screen then is populated with the default IP addresses from the board.

4. Change the Authorized PC IP address to the normal working IP of your PC.

NOTE

This IP address MUST be used for maintaining the alarm system.

5. In the IP Runner link pane, select the radio button required for the network

the Runner Link is connected to.

If a static address is needed all the required information must be entered

manually.

6. In the Receiver pane, change the IP addresses of the Receiver servers to

those of the Monitor Service Provider.

7. Enter the correct account number given by the Service Provider so that the

unit can be found rapidly when the operator needs to contact it.

The Monitor Service Provider is able to contact the unit by using the Account

number, which is the actual address of the unit.

8. Click the

button.

The screen closes and only the green SYS LED continues to blink. The other

two LEDS are OFF.

9. Set the IP of your laptop back to your normal working IP.

10. Disconnect the cross cable from the Runner Link and connect the Runner Link

to the LAN or WAN.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 28 29

Keine Kommentare

Crow Runner Link Bedienungsanleitung Seite 14